Removing The Side Panels; Installing The Motherboard; Installing Pci-E/Pci Card(S); Installing The Psu - Corsair CARBIDE Serie Guia De Instalacion

CARBIDE SERIES
®

1. Removing the Side Panels

Simply remove the
thumbscrews then slide the
side panels back and out.
Note: CORSAIR recommends
removing both side panels and
setting them aside when building
your system to avoid accidental
damage. Both side panels are
interchangeable and should be
removed to reduce clutter.

2. Installing the Motherboard

First, install your
motherboard's I/O shield
(see your motherboard's
manual for guidance).
Align your motherboard with
100R STEP1
the pre-installed standoffs.
Use the provided screws
b
to secure the
motherboard to the
motherboard tray.
5
100R
100R Step 3

3. Installing PCI-e/PCI Card(s)

Remove thumbscrews and
corresponding slot cover(s).
Install the add-on card and
secure with thumbscrews.
100R Step3
4. Installing the PSU (Power Supply Unit)
Position the PSU on the
bottom of the case then align
the case holes and secure the
PSU with screws provided with
your power supply.
6