Powering The Case Fans; Installing The Front I/O Connectors; Frequently Asked Questions - Corsair CARBIDE Serie Guia De Instalacion

CARBIDE SERIES
®

9. Powering the Case Fans

After locating your 3 or 4
pin fan headers on your
motherboard (see your
motherboard's manual
for fan header locations),
plug in the included fan cable.

10. Installing the Front I/O Connectors

See your motherboard's
manual for front panel header
locations and pin-outs.
USB 3.0
HD AUDIO
9
100R
POWER SW POWER LED +
RESET SW POWER LED -

Frequently Asked Questions

1. How do I remove the I/O Panel ?
If needed, you can uninstall your I/O panel by removing the front
fascia (step 5) then unscrewing the 2 screws at each side of panel.
(see drawing)
2. Does the polarity matter with the I/O panel's power and reset header?
No, only the LED headers.
3. Who should I contact if I received my case damaged or one of the
fans is no longer working?
Please go to support.corsair.com and request an RMA
so that we can replace the damaged part(s).
4. Where can I mount a fan?
Fan Mount Locations
Front x2 120mm or x2 140mm
Top
Rear
Bottom
Side
Mid
To learn more about this case visit the product page at corsair.com.
x2 120mm
120mm
x
x
x
10