Controls; Remote Control - GE AEM08 Guia De Instalacion Y Manual Del Propietario

Controls

Features and appearance will vary.
temperature or delay time Set mode.
Power
On/Off
Auto
High
Med
Low
Fan
NOTE: The display always shows the room temperature
setting the Set temperature or the Delay timer.
Air Conditioner Controls
Controls
ower Pad
1. P
Turns air conditioner on and off. When turned on, the
display will show the room temperature.
isplay
2. D
Shows the room temperature or time remaining on the
Delay timer. Shows the Set temperature while setting
the temperature in Cool or Energy Saver modes.
emp Increase
3. T +
mode. The Set light will turn on while setting..
Delay Increase
4.
remote control will set the delay time when using the
setting.
an Speed Pad
5. F
or Auto on the unit. NOTE: On the remote control, use
turn Auto
fan on.
ode Pad
6. M
Fan Only mode.
Note: The default temperature reading on the display is degree Fahrenheit ( °F). To change the
display to degree Celsius (°C), press the Temp Increase
and hold for 3 seconds. Repeat the process to change back to degree Fahrenheit (°F)
4
Set
Cool
Fan Only
Energy Saver
Reset Delay
Mode
Filter 1-24 Hrs
/Decrease – Pads
/Decrease – Pads
+
delay timer is set.
+
Delay
-
Delay timer
Decrease
Mode select
Fan speed
Decrease
8
Temperature
set Increase
and
Decrease
elay Pad
7. D
Delay ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF—When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
pad on the remote control. Each touch of the Increase
timer in 1-hour intervals. The Set light will turn on while
setting.
time if desired.
8. Filter Reset Pad
of run time as a reminder to clean filter. Press Reset
time.
and Temp Decrease
Fan Fan

Remote Control

buttons together
Delay
timer
Increase
Auto Fan
on
Fan speed
Increase
49-7812