Installing The Device; Connecting The Device - Atlantic 2012 Serie Manual De Uso

1) Location of the device
- This device was designed to be installed in resi-
dential premises. In any other case, please call
your distributor.
- Installation must comply with the standards cur-
rently enforced in the country of use.
- Locate the device within minimum distances
from obstacles.
do not install the device in a draft likely to
affect its control (under centralised mecha-
nical ventilation, etc...).
do no install it under a fixed mains outlet.
do not install shelf above the device.
In order to avoid a hazard for very young children, this device should
be installed so that the lowest heated rail is at least 600 mm above
the floor.

2) Connecting the device

i
nSTaLLing The deviCe
Panel heater cable
Live=brown
Neutral=blue
Pilot wire=Black
Two possible cases
1st case: only one heater
2nd case: multiple heaters
volume 1 No electrical device
volume 2 Electrical
IPX4 (Standard EN
60335-2-43
: 2003/A2: 2008)
LIVE
Electricity
grid
NEUTRAL
The pilot wire end is insulated
and not further connected
The pilot wire of all heaters in a
control group, up to a maximum
of 20 units with any one them used
as the Master, are connected
by a 1.0mm 2 220-240V insulated cable
17
150
mini
gB
150
mini
281 mini
200 mini
device