BIG ASS FANS COLD FRONT 100 Manual De Operación Y Mantenimiento página 4

Carefully examine the carton for damage before opening. If the carton is
damaged, notify the shipping company immediately.
Install casters
1. Locate the package of four (4) casters and remove from box.
2. Lay box on its side and carefully open bottom of box. DO NOT STAND BOX
UPSIDE DOWN.
3. Install the four casters.
4. Stand cooler up on casters and remove box.
The cooler has been factory tested and is ready to use. Place the cooler on level
ground with the casters locked to prevent inadvertent movement.
Connecting the water supply
The cooler comes equipped with a female garden hose water source connection.
Use a standard garden hose (not provided) to connect the water supply to the
cooler.
Do not connect to any water source where water pressure exceeds 120 PSI.
This will cause permanent damage to the cooler.
Connecting the electrical supply
The cooler should be plugged into a fused or breaker-protected circuit. Refer
to Table 1 for circuit size requirements.
Amperage and Circuit Requirements
Model
Cold Front 100
Cold Front 200
2
WWW.BIGASSFANS.COM
ASSEMBLY
IMPORTANT
SETUP
CAUTION
IMPORTANT
Volts +/- 10%
120 V
120 V
© 2020 DELTA T LLC
Frequency Min. Circuit Size
60 Hz
60 Hz
ALL RIGHTS RESERVED.
15 A
15 A
Table 1: Electrical Requirements
Running
Amps
1.5 A
2.7 A