Tabla de contenido
Publicidad
SECTION 4 - FINAL ASSEMBLY
1. Raise door frame and install the counterweight(s), supplied with your cabinet, into the counterweight tray (inside rear of cabinet).
Door should remain open.
2. Carefully hang door mirror on door frame.
1
3. Make door electrical connections to door mirror (if equipped-depends on model).
4. Secure door mirror to door frame by installing 4 screws (203-1514) on the inside lower edge of door frame, using the supplied 3/32
Allen Key. Do not over tighten.
4
[203-1514]
5a. Lower and raise door fully to check proper operation.
5b. Verify door can be opened partially and will stay open when released.
© 2019 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
2
8
Part no. 209-1311-rB rev. 08/21/19
Uplift Tech Cabinet
Publicidad
Tabla de contenido
