To Reset To The Beginning Of The Color Sequence; Section 5. Twelve (12) Volt Installation - Zodiac Jandy Pro Series Manual Del Propietário

Page 10
4.2

To Reset to the Beginning of the Color Sequence

Begin this procedure with the light turned ON.
Turn the light OFF, wait five (5) seconds, then turn ON, the light will return
to the beginning of the color cycle (Alpine White).
NOTE To synchronize colors on multiple Jandy Pro Series Nicheless
Underwater LED Light systems wired to separate switches, perform
the above actions on all of their switches simultaneously. All Jandy
Pro Series Nicheless Underwater LED Lights will synchronize
automatically if activated by the same switch. No other accessories
are required.
Section 5.
A 12-14 Volt AC Transformer must be used to power all 12-Volt lights.
NOTE For optimum performance Jandy Pro Series recommends not
exceeding the load factor specified by the instructions included with
the transformer.
To ensure maximum safety, use only a Class 2 transformer that can supply
12-14 Volts AC to power all 12-Volt lights. The transformer must be listed
or certified by a Nationally Recognized Testing Laboratory (NRTL) for the
intended use.
To prevent risk of fire which could result in property damage,
and to ensure optimum performance, do not exceed the load
factor specified in the instructions provided by the transformer
manufacturer
.
ENGLISH
Twelve (12) Volt Installation
CAUTION
Nicheless Underwater LED Lights | Owner's Manual