Section 3. Wiring Options For Controlling; Jandy Pro Series Nicheless Led Lights - Zodiac Jandy Pro Series Manual Del Propietário

Nicheless Underwater LED Lights | Owner's Manual
Figure 3. Attach the assembled light and cable to the docking ring
Section 3.
Pro Series Nicheless LED Lights
NOTE The Jandy Pro Series Nicheless LED Lights are not compatible
with light dimmers. Do not wire the Jandy Pro Series Nicheless
Lights to any dimming circuitry.
To the extent allowed by local installation codes in effect in the installation
jurisdiction and capacity of the electrical equipment, multiple Jandy Pro
Series lights may be controlled with a single switch and transformer so
their colors may be synchronized.
Separate switches may be used to control the on/off and color functions
of each set of Jandy Pro Series Nicheless Lights (a 'set' being all the
lights wired to a common 12 VAC transformer). It is recommended that
these switches be located next to each other to facilitate simple color
synchronization when desired. If color synchronization is critical, switches
must be operated simultaneously.
3.1 Wiring to an AquaLink
The Jandy Pro Series Nicheless LED Lights can be controlled by an
AquaLink controller. Connect the transformer powering the lights to one
of the auxiliary relays in the AquaLink.
Refer to Figure 4 to connect the Jandy Pro Series Nicheless LED Lights to
the Power Center.
3
1
Wiring Options for Controlling Jandy
ENGLISH
2
Controller
®
Page 7