Wiring To A Time Clock; Wiring To A Switch - Zodiac Jandy Pro Series Manual Del Propietário

Page 8
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION,
which could result in serious injury or death.
Circuit Interrupter (GFCI) must be provided for 120 Volt transformers.
The conductors on the load side of the GFCI circuit shall not occupy
conduit, boxes, or enclosures containing other conductors unless the
additional conductors are also protected by a GFCI. Refer to local
codes for complete details.
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION,
which could result in serious injury or death.
Pro Series Nicheless LED Lights are only available for 12-volt
AC power. Use ONLY a 120VAC to 12 VAC step-down, class 2
transformer which is NRTL-listed/certified for the application. For
more information about 12-volt installations, refer to Section 5 of this
manual.
3.2

Wiring to a Time Clock

The Jandy Pro Series Nicheless LED Lights can be wired to a time
clock to operate the lights automatically.
3.3

Wiring to a Switch

The Jandy Pro Series Nicheless LED Lights can be wired into a switch
to manually operate the lights. Refer to Figure 4 to connect the lights
into the switch.
Figure 4. Wiring Jandy Pro Series Nicheless Underwater Lights
ENGLISH
WARNING
WARNING
Line Black
Neutral White
GFCI
Ground Ground
4
Wiring Jandy Pro Series Nicheless Underwater Lights
Nicheless Underwater LED Lights | Owner's Manual
A Ground Fault
The Jandy
AquaLink Aux
Relay or Switch
Black
120 volts to
White
12VAC
Green
Transformer