Maintenance - ArmorAll DVTB202 0901 Manual De Instrucciones

DEFLATING AN OBJECT
1. Connect the hose to the vacuum port. (Fig. 6)
2. Push the desired inflator nozzle onto the free end of the hose. (Fig. 19)
3. Make sure battery is correctly installed. For installation instructions see page 7.
4. Insert the inflator nozzle into the air valve of the item being deflated.
5. Turn the motor on by flipping the switch to the 'I' ON position. Once you have completed
deflating, turn the motor off by flipping the switch to the 'O' OFF position.
6. Remove the battery.
WARNING!
AND REMOVE THE BATTERY PACK FROM THE CHARGER OR TOOL BEFORE
PERFORMING ANY MAINTENANCE. NEVER DISASSEMBLE THE TOOL, BATTERY PACK
OR CHARGER.
IMPORTANT!
MAINTENANCE, MAKE SURE THAT THE TOOL IS SWITCHED OFF AND REMOVE THE
BATTERY BACK TO PREVENT ACCIDENTAL START-UP.
EMPTYING & CLEANING THE COLLECTION TANK
1
1. Verify that the battery has been removed from the battery bay. (Fig. 1)
2. Disconnect the hose from the vacuum.
3. Undo the latches and remove the power head from the collection tank.
4. Clear all dirt or debris from the collection tank and clean with mild soap and water. Allow to dry
before replacing the power head. (Fig. 2)
STORAGE
Before storing your vacuum cleaner, the collection tank should be emptied and cleaned. The
battery should be stored in a dry location. The accessories should be cleaned and stored so they
can be readily available when needed. Store wet/dry vacuum indoors.
REPAIRS
Repairs for this wet/dry vacuum should be performed only by qualified service personnel using
only identical replacement parts.

MAINTENANCE

TO REDUCE THE RISK OF INJURY, ALWAYS UNPLUG THE CHARGER
BEFORE CLEANING YOUR VACUUM OR CARRYING OUT ANY
2
11