Tool Assembly - Milwaukee 8950 Manual Del Operador

Assembling Dolly (Cat. No. 8955) (Fig. 1)
Assemble as shown in the diagram. You will need a hammer and a
phillips screwdriver.
1. Place wheels on rear frame (B) by tapping in the axle (C), fitting the
wheel (D) on the axle and tapping a cap nut (E) on with a hammer.
2. Insert caster socket (G) into front frame (F) and secure it with the
phillips screw (I).
3. Align front frame (F) and rear frame (B) so that they fit together and fit
lip of tank (J) into the grooves in front and rear frames.
4. Secure frame (B and F) to the tank by placing the hex bolts (K) through
the holes in dolly and securing them with nut (N) and washer (M) as
shown.
5. Insert caster (H) into into caster socket (G) and push down until caster
snaps into place.
Fig. 1
F
G
I
H
Installing Handle (Cat. No. 8955) (Fig. 2)
You will need either a flat blade screwdriver or a socket driver and a
wrench or a pair of pliers.
1. Place dolly handle between tank and side handle on either side of the
tank.
2. Fasten tightly with slotted hex head screws.

TOOL ASSEMBLY

A
B
C
D
J
K
L
M
N
Fig. 2
Attaching Caddy and Casters (Cat. No. 8936-20)
You will only need a Phillips screwdriver.
1. Slide caddy over attaching boss' on bottom of vacuum cleaner tank.
2. Install phillips screws and tighten.
3. Slide caster housings over attaching boss' on bottom of vacuum cleaner
tank.
4. Install phillips screws and tighten.
5. Push caster wheel shafts into attaching holes on bottom of caster
housings and bottom of caddy until they click.
Fig. 3
E
Page 5