Set Contents; Setting Up The Gigavideo70™ Transmitter - Marmitek GIGAVIDEO 70 Modo De Empleo

20132_20061127_UG_GV70_6t
1

SET CONTENTS.

1 Transmitter.
1 Receiver with modulator.
2 Power adapters.
1 RCA/RCA cable.
1 Scart/RCA adapter.
1 RCA/Mini DIN cable.
1 Scart/scart RCA adapter.
1 3.5 mm jack plug/RCA adapter (audio).
1 IR extender with 3 LEDs.
1 User manual.
2 SETTING UP THE GIGAVIDEO70™ TRANSMITTER.
1. Connect the wire with the Mini DIN plug (small connector with pins) to the Mini DIN
connector of the transmitter [C].
2. Connect the other end of the cable to the Audio/Video OUT jacks of the video source
you want to transmit the signal from (e.g. your VCR, DVD, Satellite or TV: connecting the
transmitter to your VCR or Satellite receiver, allows you to choose channels independent
from your main TV). If your video source is equipped with a SCART connector use the
SCART Adapter labelled TRANSMITTER (the one with the extra wires attached on the
side). If there already is a SCART cable attached to the SCART connector of your source,
un-plug it first. Now plug in the SCART Adapter labelled TRANSMITTER.
To re-establish your existing connection plug in your original SCART cable into the back
of the SCART Adapter. Connect the Audio/Video cable from the transmitter to the
yellow, red and white connectors of the SCART Adapter. See the picture for more details.
3. Set the Channel-switch [A] on A.
4. Switch the Power slide switch [B] into the 'OFF' position.
5. Plug the supplied mains adaptor into a wall outlet and connect the plug at the rear side
of the transmitter [E]. Only use the supplied mains adaptor!
6. Switch the Power switch [B] to the 'ON' position.
7. Position the transmitter in a convenient location and orient the antenna [K].
8. Put the side antenna [J] in an upright position.
4
28-11-2006 13:04 Pagina 4
GIGAVIDEO70™ TRANSMITTER
TO SCART
VIDEO
SCART ADAPTER
"TRANSMITTER"
ORIGINAL SCART CABLE TO TV
MARMITEK