Connecting The Gigavideo70™ Receiver; Fine Tuning Your Gigavideo70™ Set - Marmitek GIGAVIDEO 70 Modo De Empleo

20132_20061127_UG_GV70_6t
If you have several A/V components:
If you have two or more A/V components (e.g. VCR, Cable box, DVD or satellite receiver) that you
want to watch in another room, they will probably already been hooked up to the local TV in
series. To connect the GigaVideo70™ Transmitter you just need to identify the last component in
the chain and connect the 'Line OUT' or scart to the GigaVideo70™ 'Transmitter IN' jacks.
Video signal and S-VIDEO signal.
The connector at the backside of the GigaVideo70™ transmitter is not a S-VIDEO connector.
This is why you can't connect S-VIDEO signals to the GigaVideo70™, but only video signal.
When you only have S-VIDEO output on your equipment (you can recognise a S-VIDEO
connection by a small round mini DIN plug with 4 pins), then you can use the Marmitek S-
VIDEO to composite video adapter (art. no. 09388).
3 CONNECTING THE GIGAVIDEO70™ RECEIVER.
1. Plug a set of A/V cables into the output on the back of the GigaVideo70™ receiver [H+I].
Make sure the colour of the plug and output connection matches.
Your set also consists of a modulator, which means you can also connect the receiver via
an antenna cable, if your TV has not got a SCART in (antenna cable not included).
Connect the GigaVideo70™ to your TV using the RF out [G]. If you are using the RF out,
you need to set your TV to channel 36.
2. Turn the On/Off switch [B] to 'OFF'.
3. Insert the power plug into the DC in [E] on the back of the video receiver and plug the
power adapter included into a wall socket. Please only use the adapter provided!
4. Connect the other end of the connection cables to the A/V in of the second TV or video
recorder. Make sure the colours match. You can also use the SCART adapter.
5. Turn the On/Off switch [B] to 'ON'.
6. Set to channel selector [A] (A-B-C-D) to A.
7. Place the receiver in an easy accessible spot with enough space around it. Aim the flat
side of the dish antenna [K] at the transmitter.
8. Extend the stick antenna [J] on the side.
4 FINE TUNING YOUR GIGAVIDEO70™ SET.
Make sure your A/V equipment is switched on.
Scart Switch the receiving TV on and select the A/V channel (normally found on the
"0" or "AV" button). The picture should now automatically be there, no
tuning is required.
Modulator Tune your TV to channel 36 or 48.
The wireless GigaVideo70™ usually works best with the indented faces of the antennas [K]
on the Transmitter and Receiver unit look at one another. Sometimes however distance,
reflections and other effects in the home may affect the signal so that some adjustment of
either Transmitter or Receiver antenna may be necessary to get the best signal. If still
experiencing difficulty, try changing the "ABCD" channel selector [A] and change channels.
Remember though both the receiver and transmitter must be on the same channel.
The maximum distance between transmitter and receiver depends on local circumstances, but
on average the distance is up to 30m, through walls and floors.
GIGAVIDEO 70
28-11-2006 13:04 Pagina 5
5