Power Supply; Intercom Panel; Options; Technical Support - Warranty - Extel Compact Instrucciones De Uso E Instalación

b. Power supply
• Reference: 830216
• Adapter: 100-240 V∼, 50/60Hz; 17 V , 1.5A
If the power cord is modified, make sure to follow the polarity when re-connecting (fig. 7)
c. Intercom panel
• Colour C-MOS camera: 640 x 480
• Camera angle: H70° V60°
• Operating temperature: from -10°C to + 45°C
• Sensitivity: 3 Lux
• Protection rating: IP44
• Dimensions with shield (mm): 180 x 72 x 47
• Strike plate control: 12 V - 1 A maximum
• Gate control: breaking capacity 12 V - 2 A

8. OPTIONS

• All Extel electric strike plates
• All Extel electric locks
• All Extel motors
• Modulo B modular power supply (wiring fig. 7)

9. TECHNICAL SUPPORT - WARRANTY

Failure
• The monitor will not turn
on
• Poor picture and/or
sound
• Image is too bright
• Black screen, no
doorbell ring
• No sound coming from
the intercom panel
• Monitor switched off (indi-
cator LED switched off)
Latest version of the downloadable instructions in colour:
GB5
(PL COMPACT)
Cause
• The monitor is not
receiving power
• Protection triggered
• Environment
• Wires too short
• Camera position
• Installation
• Insects
• Poor connection or short
circuit on the line
If needed, consult our technical website at www.cfi-extel.com
0 892 350 069
EXTEL COMPACT - ADDCOMPACT
Solution
• Check the power connection
• Check wiring on the intercom panel and dis-
connect from power supply for 10 seconds
• Check that the wires used have the right gauge
and that the connection wires for the video inter-
com are not in the same conduit as the 230 V wires.
• Use at least 5 m of wires
• Do not directly expose the camera lens to the
sun or a reflective surface.
• Check the settings
• The connection wires between the monitor
and the intercom panel are switched (1 and 2)
• Check that the intercom panel microphone
hole is not obstructed
• Resolve the connection problem, switch off the
power for 10s then reconnect
Service 0,35 € / min
+ prix appel
www.cfi-extel.com