Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
TOOLS REQUIRED
Hammer
Safety goggles
Measuring tape
Wall hardware
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make sure all parts
are present. Compare parts with the Hardware
Included list. If any part is missing or damaged,
do not attempt to install the product.
□ Determine the desired mounting location,
and mark the wall where the unit will be
installed.
NOTE: For secure installation, the unit
must be mounted to at least one wall stud.
3
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws
with washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate
locations and insert toggle bolts with washers (not included).
□ For concrete wall installation, drill 1/4 in. holes at the
appropriate locations and insert #12 wall anchors,
followed by #12 x 3 in. screws (not included).
4
INSTALLING THE VANITY TOP
IMPORTANT: Do not use plumber's putty.
NOTE: The faucet, drain, and supply lines are not included. Install these
parts to the vanity top according to the manufacturer's instructions.
□ Apply silicone caulk/sealant (not included) to all four corners of the cabinet.
□ Place the vanity top onto the cabinet.
□ Position the top so that it has an equal amount of overhang on each side
and use a level to ensure the vanity top surface is level.
□ Apply silicone onto the seam between the edge of the vanity top and the
wall, smooth the bead, and allow to cure before use.
NOTE: Matching side and back splashes available, sold separately.
To purchase, visit your local Home Depot store or go to homedepot.com.
5
INSTALLING THE HARDWARE
□ Attach the handles (AA) to the cabinet with the provided screws (BB).
Use and
Care Guide
Vanity Combo
Phillips screwdriver
Power drill
Caulk/sealant
Model# PPAVLDVR18
Model# PPAVLCAB18
Model# PPAVLDVR24
Model# PPAVLCAB24
Model# PPAVLDVR30
Model# PPAVLCAB30
HARDWARE INCLUDED
AA - Handle x 2
Level
2
POSITIONING THE CABINET
□ Move the cabinet into place, and use wood
shims to level the cabinet against the wall.
AA
Please contact 1-888-774-8062 for further assistance.
Item# 1003 431 333
Item# 1003 431 343
Item# 1003 606 766
Item# 1003 606 761
Item# 1003 606 780
Item# 1003 606 777
BB - Handle screw x 4
BB
HOMEDEPOT.COM
Publicidad
Manuales relacionados para Glacier bay Combo PPAVLDVR18
Resumen de contenidos para Glacier bay Combo PPAVLDVR18
- Página 1 Model# PPAVLDVR18 Item# 1003 431 333 Use and Model# PPAVLCAB18 Item# 1003 431 343 Model# PPAVLDVR24 Item# 1003 606 766 Care Guide Model# PPAVLCAB24 Item# 1003 606 761 Model# PPAVLDVR30 Item# 1003 606 780 Vanity Combo Model# PPAVLCAB30 Item# 1003 606 777 TOOLS REQUIRED HARDWARE INCLUDED Hammer...
- Página 2 Troubleshooting Problem Possible Cause Solution The doors do not align or The hinges are misaligned. Hold the door while loosening Up — Down the space is too big or too screws. Align the doors properly, In — Out tight between the doors. and re-tighten the screws.
- Página 3 Núm. de artículo 1003 431 333 Núm. de artículo 1003 431 343 Núm. de artículo 1003 606 766 Núm. de artículo 1003 606 761 Núm. de artículo 1003 606 780 Núm. de artículo 1003 606 777 Núm. de modelo PPAVLDVR18 Guía de uso Núm.
- Página 4 Resolución de fallas Problema Posible causa Solución Arriba — Abajo Las puertas no se alinean Las bisagras están Sostenga la puerta mientras o el espacio es demasiado desalineadas. afloja los tornillos. Alinee las grande o está demasiado puertas adecuadamente y Izquierda —...