Glacier bay CACO36-C Guía De Uso Y Cuidado

TOOLS REQUIRED
Claw hammer Safety goggles
Measuring tape Wall hardware
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make sure all parts are present.
Compare parts with the Hardware Included list. If any part is
missing or damaged, do not attempt to install the product.
□ Determine the desired mounting location, and mark the
wall where the unit will be installed.
NOTE: For secure installation, the unit
must be mounted to at least one wall stud.
3
POSITIONING THE CABINET
□ Move the cabinet into place, and use wood shims to level
the cabinet against the wall.
4
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws with
washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate locations
and insert toggle bolts with washers (not included).
□ For concrete wall installation, drill 1/4 in. holes at the
appropriate locations and insert #12 wall anchors, followed by
#12 x 3 in. screws (not included).
5
INSTALLING THE HARDWARE
□ Attach the handle (AA) to the door on the vanity with
short screws (BB) and to the drawers on the vanity
with long screws (DD).
Phillips screwdriver Power drill
Keyhole saw
Use and Care Guide
HARDWARE INCLUDED
AA - Handle
CACO36-C x 3
CACO48D-C x 5
Level
2
CUTTING THE OPENING FOR PLUMBING FIXTURES
NOTE: This step applies to vanity
cabinets with full back panels only.
□ Locate and mark plumbing on the back panel.
□ Drill a pilot hole through the back panel.
□ Use a keyhole saw to cut an opening for the plumbing fixtures.
AA
Item #100066005
Item #100066006
Model #CACO36
Model #CACO48D
Vanity Cabinet
BB - Short Screw CC - Long Screw
CACO36-C x 6
CACO48D-C x 6 CACO48D-C x 4
CC
BB
HOMEDEPOT.COM
Please contact 1-888-774-8062 for further assistance.