Input Jack - Fender PASSPORT EXECUTIVE PR 692 Instrucciones De Funcionamiento

Wireless Transmitter
DISPLAY—Displays the transmitting channel (or frequency)
and battery strength.
GAIN—Set at the factory for optimal use. Decrease GAIN
only if the Passport Executive sounds distorted even at low
volume settings. Increase GAIN only if the Passport Executive
sounds too quiet even at high volume settings.
BATTERIES—Insert two AA batteries as shown.
POWER—Wireless Transmitter ON-OFF switch.
INPUT JACK—Plug the Headset
SET—Press to activate menus and confirm selections.
UP / DOWN—Press to change channels (frequencies) and
make menu selections.
A statutory license may be required to operate this equipment in certain areas. Consult your national authority for possible require-
ments. Licensing of Fender equipment is the user's responsibility, and licensability depends on the user's classifi cation, application,
and frequency selected. Fender strongly urges the user to contact the appropriate telecommunications authority for any desired
clarifi cation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause unde-
sired operation.
Passport Executive Passport Executive
Channel Selection
Display Options
channl
disply freq
Button Lock
loc on
loc set loc off
in here.
Telecommunications Licensing Telecommunications Licensing
fender.com fender.com
• The Transmitter channel must match the receiver
channel displayed on the Passport base unit
change the Transmitter channel, first use the
buttons to select a channel, then press the SET button
to confirm your selection.
• The Transmitter can display either the transmitting
channel or frequency. To change the display, press the
SET button once. Next use the
either "CHANNEL" or "FREQUENCY," then press the SET
button to confirm your selection.
• You can lock the Transmitter buttons if desired. After
selecting the Display Option (above), use the
buttons to select either "LOCK ON" or "LOCK OFF,"
then press the SET button to confirm your selection.
To unlock, press the SET button and select "LOCK
OFF."
Headset Microphone
HEADSET—Plug into the Wireless Transmitter Input Jack
.
. To
buttons to select
7 7