Install The Header Bracket - Craftsman 139.53982SRT Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
STEP
2
Install
the Header
Bracket
You can attach the header bracket either to the wall
above the garage door, or to the ceiling. Follow the
instructions which will work best for your particular
requirements. Do not install the header bracket
over drywall. If installing into masonry, use
concrete anchors (not provided).
WALL HEADER BRACKET INSTALLATION
• Center the bracket on the vertical centerline with
the bottom edge of the bracket on the horizontal
line as shown (with the arrow pointing toward the
ceiling).
• Mark the vertical set of bracket holes. Drill 3/16"
pilot holes and fasten the bracket securely to a
structural support with the hardware provided.
HARDWARESHOWNACTUALSIZE
Lag Screw
5/16"-9xl-5/8"
Wall Mount
Optional
Mounting
Holes
Header
/
/
/
j
--
j
I
j
Highest Point of
Garage Door Travel
Vertica_
Centerline
Garage
Door
Vertical
Centerline
Lag Screws
5/16"x9x1-5/8"
CEILING HEADER BRACKET INSTALLATION
• Extend the vertical centerline onto the ceiling as
shown.
• Center the bracket on the vertical mark, no more
than 6" (15 cm) from the wall. Make sure the arrow
is pointing away from the walt. The bracket can be
mounted flush against the ceiling when clearance
is minimal.
• Mark the side holes. Drill 3/16" pilot holes and
fasten bracket securely to a structural support with
the hardware provided.
Ceiling Mounting
Holes
Header
_
Bracket
/
6" (15 cm) Maximun
Door
Lag Screws
-_5/16"x9x1-5/8"
Header Wall
14

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

139.53995srt

Tabla de contenido