Using The Walt-Mounted Door Control; To Open The Door Manually; Disconnect The Trolley - Craftsman 139.53982SRT Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Using
the
Wall.Mounted
Door
Control
THE PREMIUM CONTROL
CONSOLE
Press the lighted push button to
open or close the door. Press
again to reverse the door during
the closing cycle or to stop the
door while it's opening.
Lighted
Light
Button
Lock
utton
Light feature
Press the Light button to turn the opener light on or
off. It will not control the opener lights when the door
is in motion, if you turn it on and then activate the
opener, the light will remain on for 4-1/2 minutes.
Press again to turn it off sooner. The 4-1/2 minute
interval can be changed to 1-1/2, 2-1/2, or 3-1/2
minutes as follows: Press and hold the Lock button
until the light blinks (about 10 seconds). A single blink
indicates that the timer is reset to 1-1/2 minutes.
Repeat the procedure and the light will blink twice,
resetting the timer to 2-1/2 minutes. Repeat again for
a 3-1/2 minute interval, etc., up to a maximum of four
blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from
hand-held remote controls. However, the door wilt
open and ctose from the Door Control, the Outdoor
Key Switch and the Keyiess Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push button light will flash as long as
the Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push button light will stop flashing.
The Lock feature will also turn off whenever the
"learn" button on the motor unit panel is activated.
Additional feature when used with the 3-function
hand-held remote
To control the opener lights:
In addition to operating the door,
you may program the remote to
operate the lights.
1. With the door closed, press and hold a smalt
remote button that you want to control the light.
2. Press and hold the Light button on the Premium
Control Console.
3. While holding the Light button, press and hold the
Lock button on the door control.
4. After the opener lights flash, release alt buttons.
To Open
the
Door
Manually
• To prevent possible SERIOUSINJURYor DEATHfrom
a falling garage door:
- If possible, use emergency release handle to
disengage trolley ONLYwhen garage door is
CLOSED.Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
- NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope
knot becomes untied, you could fall.
DISCONNECT THE TROLLEY:
The door shoutd be fully
Trolle
closed if possible. Pull
-
down on the emergency
release handle (so that the
trolley release arm snaps
Trolley
.._.%
into a vertical position) and
Release
arn
lift the door manually. The
(inManuaI
Disconnect
lockout feature prevents the
Position)
trolley from reconnecting
automatically, and the door
I_
can be raised and lowered
manually as often as
necessary.
Lockout position
(Manual disconnect)
TO RE-CONNECT
THE
TROLLEY:
Pull the emergency
release handle toward the
opener at an angle so that
the trolley release arm is
horizontal The trolley wilt
reconnect on the next UP
or DOWN operation, either
manually or by using the
door control or remote.
Trolley
-
I
TRr_lleeaYse
Emergency
"__
Release Handle
(Down and Back)_
÷
s
To _connect
32

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

139.53995srt

Tabla de contenido