One-Piece Door Installations; One-Piece Door Without Track - Craftsman 139.53982SRT Manual Del Propietário

Planning (continued)
ONE-PIECE DOOR INSTALLATIONS
• Generally, a one-piece door does not require
reinforcement. If your door is lightweight, refer to
the information relating to sectional doors in
Installation Step 11.
• Depending on your door's construction, you may
need additional mounting hardware for the door
bracket (Step 11).
Without a properly working safety reversal system,
persons (particularly small children) could be
SERIOUSLYINJUREDor KILLED by a closing garage
door.
• The gap between the bottom of the garage door and
the floor MUST NOT exceed 1/4" (6 ram). Otherwise,
the safety reversal system may not work properly.
• The floor or the garage door MUST be repaired to
eliminate the gap.
ONE-PIECE DOOR WITHOUT TRACK
Header Wall
FINISHED CEILING
Support bracket
& fastening
hardware is required.
See page f 7
Rail
Slack in chain tension
is normal when garage
door is closed
Motor Unit
Access
Door
©
f
Safety Reversing Sensor
Safety Reversing
Sensor
Gap between floor
and bottom of door must not exceed 1/4" (6 ram)
ONE-PIECE DOOR WITH TRACK
Wait-mounted
Door Control
_/_ CLOSED POSITION
Trolley Stop Bolt Cable Trolley
I
Bracket Rail
Door Bracket
Emergency
Release Straight Curved Rope & Handle
Door Door
leader Arm Arm
Call
Access
I
Door I
()I
f_
Reversing
Gap between floor Sensor
_- and bottom of door
Safety must not exceed I/4" (6 mm)
Reversing Sensor
CLOSED POSITION
Trolley Stop Bolt Cable Chain
_ L' I
Header Curved _ :_ilg
Bracket Door Ar Rml
ooo©oooo©©o)
D r I E ency
_oo r i ht Release
Bracketoor Stag _i_c_se& e
Door _ht Rope &
Garage Arm Handle
5