Cub Cadet FastAttach Manual Del Operador página 8

Assemble Spot Sprayer Wand to
Hose
1. Connect spot sprayer rod to wand
handle. See Figure 3-5.
Figure 3-5
2. Place spot sprayer wand in the wand
clips located on the front of the sprayer
tank. See Figure 3-6.
Figure 3-6
8 S 3— A
ection SSembly
Connect Wiring Harnesses
1. Make sure that the switch is in the OFF
position. See Figure 3-7.
2. Connect the battery harness clips to
the battery terminals. Remove the
plastic cover, if present from the positive
battery terminal and connect the red
wire to the positive terminal, then
connect the black wire to the negative
terminal. See Figure 3-8.
FastAttach™ Front Attachments
Description
All-Season Plow
Brush Guard
More coming soon. Visit your local Cub Cadet Dealer or CubCadet.com for more information.
FastAttach™ Rear Attachments
Spreader (100 lb capacity)
Cargo Carrier (80 lb capacity)
Bagger (42" and 46" Decks)
Sprayer / Cargo Carrier Combo
More coming soon. Visit your local Cub Cadet Dealer or CubCadet.com for more information.
& S -U
et p
Figure 3-7
Part Number
19A30037100
19A30038100
19A30028100
19B30029100
19A30030100
19A30035100
Figure 3-8
3. Connect the battery wire harness to the
pump wire harness. See Figure 3-9.
Figure 3-9
Note: A small gap may be present when
connectors are assembled.
CAUTION:
After installation of
the wiring harness, ensure that it
does not obstruct or make
contact with any moving parts of
you tractor. If needed, zip ties (not
included) can be used to secure
the wiring harness to the tractor.