Milwaukee 48-22-8561 Manual Del Operador página 7

Removing the Drawers
1. Fully extend and empty the drawer.
2. Depending on the side, either lift or lower the
release lever on both sides so the slides can ride
over the stops. Pull out to remove.
Installing the Drawers
1. Pull the slides and slide carrier out until fully ex-
tended.
2. Hold the slide on the cabinet while aligning it with
the slide on the drawer.
3. Slightly insert one side and repeat for the other
side.
4. Slowly push the drawer until it is fully closed to
engage the slide.
5. Open and close the drawer to verify proper op-
eration.
MAINTENANCE
To reduce the risk of injury, contact
WARNING
MILWAUKEE Corporate After Sales
Service Technical Support for ALL repairs and
replacement parts.
Maintaining the Bench
Keep your bench in good repair by adopting a regular
maintenance program. Before use, examine the gen-
eral condition of your bench. Check for loose screws,
misalignment, binding of wheels, broken parts and
any other condition that may affect its safe operation.
Do not use a damaged bench.
Maintaining the Casters
Grease the casters annually using high quality bear-
ing grease.
Release Lever
Grease
Points
Maintaining the Drawers
1. Periodically clean the drawer with a mild detergent
and water.
2. Remove grease and oil in drawer with a standard,
nonflammable cleaning fluid.
3. The use of drawer liners is recommended to
protect the finish inside the drawers and make
the drawers easier to clean. Drawer liners can be
cleaned with soap and water.
4. Lubricate the slides semi-annually with general
purpose grease or equivalent.
This steel product has been coated with industrial
powder coating for a durable finish. To help protect
the powder coated finish, do not allow harsh chemi-
cals (oil, grease or other chemical) to remain on the
powder coating surface. Use a glass cleaner to clean
and maintain all surfaces of powder coating.
Keep the bench handles and wheels clean, dry and
free of oil or grease. Use only mild soap and a damp
cloth to clean your bench since certain cleaning
agents and solvents are harmful to plastics. Some of
these include: gasoline, turpentine, lacquer thinner,
chlorinated cleaning solvents, ammonia and house-
hold detergents containing ammonia. Never use
flammable or combustible solvents around bench.
For service and repair information, including the or-
dering of service parts, call our Corporate After Sales
Service Technical Support line at 1-800-SAWDUST,
or visit our website at www.milwaukeetool.com.
ACCESSORIES
Modifying the bench to accept
WARNING
other accessories may be hazard-
ous, resulting in injury or property damage. Use
only specifically recommended accessories ac-
cording to the manufacturer's instructions.
For a complete listing of accessories, go online to
www.milwaukeetool.com or contact a distributor.
7
Grease
Points
Cleaning
Service