Philips SDV3427W/27 Manual Del Usuario página 12

5) Installing the assembled antenna.
a) Locate a position on the house that is far away
from power lines. Refer to the Important Safety
Instructions.
b) Secure the Mounting Bracket to the location
selected for the antenna. The 1/4 X 2" Lag Screws
have been provided for some installations.
c) Connect the "J" mount to the Mounting Bracket
(Fig. 5a) using the M6 X 50mm Bolts, M6 Locking
Nuts and M6 Washers.
Fig. 5a
d) Position the J-Mount perpendicular to the
ground using a small level.
e) Slide the Antenna onto the "J" Mount. (Fig. 5b)
Point the small end of the antenna in the direction
of the broadcast towers in your area. Tighten the
Wing Nuts on the "U" Bolt when the antenna is in
the desired position.
Fig. 5b
12