Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
XMD Installation
1. Mount the bracket to a flat
surface using the included hard-
ware, 2x #8-32 x ½ T18-8
stainless screws. Recommended
torque is 22 in-lbf.
2. Once the location for the XMD
is known, line up the bracket
edges to the XMD and slide it
into place until the release tab is
secured overt the retaining pin.
XMD Removal
3. Insert a small flat head screw
driver into 1 of 4 access points.
4. Slide the flat head tip of the
screw driver under the release
tab.
5. Twist the screwdriver in order to
raise the release tab over the
retaining pin.
6. While applying pressure to the
release tab, slide the controller
off of the mounting bracket.
www.sunhydraulics.com
5
© 2017 Sun Hydraulics Corporation
Pub.#999-901-853 November 2017
Patent Pending
Patent Pending
1
1
E
IP69K
11
3
*
*
*
*
2
4
Release tab
Retaining
pin
Access
points
6
EN
11
Publicidad
Tabla de contenido
