Connections & Settings (Multi Room/Single Room); Preparing The Receiver; Outline Dimensional Drawing; Attaching/Removing The Front Cover - Sony STR-ZA3000ES Guia De Instalacion

Connections & settings (multi room/single room)

Preparing the receiver

Outline dimensional drawing

Top
Front
430 mm (17 in)

Attaching/removing the front cover

The front cover can be completely removed from the receiver.
Remove the front cover by inserting
your fingers under the cover.

Setting up the receiver

We recommend that you activate the following menu items in advance.
To activate the network standby mode
Select [Setup] - [Network Setup] - [Network Standby] - [On] from the home menu.
To turn on the control mode to make an external controller connection
Select [Setup] - [Install Setup] - [External Control] - [On] from the home menu.
Notes
• When the receiver is in standby mode, the / (on/standby) indicator on the front panel lights up in
amber if [Network Standby] is set to [On].
• Set [External Control] to [On] to activate the network connection or to activate control from an external
controller connected to the RS232C port.
Side
10 mm (13/32 in) 378 mm (15 in)
410 mm (16 1/4 in)
7
GB