ABB Sílice 8241 Guia Del Usuario página 21

Página 0
2 . 6
µg/l
Silica (SiO )
2
DIAGNOSTIC INFORMATION PAGE 1.0
Next 5 weekly service = DD/MM
Next yearly service = DD/MM/YY
Monitor in service
SYSTEM INFORMATION PAGE 1.1
Optical system temperature = xx.x'C
Reaction block temperature = xx.x'C
Zero offset = xx.x<units>
Calibration factor = x.xx
Date (DD/MM/YY) = xx/xx/xx
Time (HH:MM:SS) = xx:xx:xx
SYSTEM INFORMATION PAGE 1.2
Time units (DD/MM/YY)
Next AUTO ZERO CAL = xx/xx/xx
Last AUTO ZERO CAL = xx/xx/xx
Next SEC CAL = xx/xx/xx
Last SEC CAL = xx/xx/xx
MAINTENANCE AND CALIBRATION. PAGE 2.0
Enter security code xxxx
ROUTINE MAINTENANCE. PAGE 2.1
5 Weekly pipe rinse = NO
5 Weekly solution replacement = NO
Annual service = NO
Default calibration parameters = NO
Alter maintenance security code =
ROUTINE MAINTENANCE. PAGE 2.2
Energise AUTO ZERO valve = NO
Energise SECONDARY CAL valve = NO
Energise EMERGENCY SAMPLE valve = NO
Switch lamp on continuous = NO
SET UP CALIBRATION. PAGE 2.3
NO Initiate manual AUTO ZERO =
SEC CAL solution value = xx<units>
Calibration date (DD/MM/YY) = xx/xx/xx
Calibration time (HH:MM) = xx:xx
AUTO ZERO frequency = xx
AUTO ZEROs between SEC. CALS = x
AUTO ZERO SEQUENCE PAGE 2.4
Reading = xxx<units>
Time to compensation = xx min
Si
Abort AZ calibrations = NO
SECONDARY CAL = NO
SECONDARY CALIBRATION SEQUENCE PAGE 2.5
Reading = xxx<unit>
Time to compensation = xx min
Si Abort SEC calibrations = NO
SAMPLE RECOVERY SEQUENCE PAGE 2.6
Reading = xxx <units>
Time to end of sequence = xx min
Zero offset = xx.x <units>
Calibration factor = x.xx
SET UP INSTRUMENT
Enter security code
SET UP INSTRUMENT
Software issue =
Control temperature =
Display units =
Alter setup security code =
xxxx
CLOCK SETUP.
Date (DD/MM/YY) = xx/xx/xx
Time (HH:MM)
WARINING: Adjusting any of the above
time parameters will alter the next
Auto Calibration Date.
NO
PAGE 3.0
xxxx
PAGE 3.1
x
xx.x'C
<units>
xxxx
PAGE 3.2
= xx:xx
A página 4