Information; In Case Of Diffi Culty; Remote Control Battery Replacement - Alpine PKG-RSE1 Manual De Operación

Ocultar thumbs Ver también para PKG-RSE1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Information

In Case of Diffi culty
If you encounter a problem, please review the items in the
following checklist. This guide will help you isolate the
problem if the unit is at fault. Otherwise, make sure the
rest of your system is properly connected or consult your
authorized ALPINE dealer.
No function or display.
• Car's ignition is off.
- Turn the ignition on.
• No fuse or blown fuse.
- Check the cause and replace the fuse.
• Incorrect connections.
- Check connection and remedy.
• Vehicle's battery is weak.
- Check the voltage of vehicle's battery.
No picture display.
• Brightness control is set for minimum brightness
control.
- Adjust the brightness.
• Incorrect setting of the mode.
- Switch to the correct mode.
- Check the connection to the source unit.
- Check the power of the source unit.
• Incorrect or open connection with the Monitor, AV
interface unit.
- Check the connection and remedy.
Picture color is poor.
• Brightness/Color/Tint/Contrast/Sharpness control
are not set to the proper positions.
- Check each control.
Spots or dotted lines/stripes appear.
• Caused by neon signs, high-voltage power lines,
CB transmitter, other vehicle's ignition plugs, etc.
- Change the location of your vehicle.
Unit does not operate.
• Monitor's power is not turned on.
- Turn on the monitor's power.
Due to continuous product improvement,
specifi cations and design are subject to change
without notice.
12
-EN
TW_PKG-RSE.indb EN12
TW_PKG-RSE.indb EN12

Remote Control Battery Replacement

Battery type: CR2025 battery or equivalent.
1
Opening the battery case
Slide out the battery cover while fi rmly pressing in
the direction of the arrow.
2
Replacing the battery
Put the battery in the case with the (+) indication
upward as shown in the illustration.
• Placing a battery in backwards way may cause a
malfunction.
3
Closing the cover
Slide the cover as illustrated until a click is heard.
Warning
DO NOT OPERATE ANY FUNCTION THAT
TAKES YOUR ATTENTION AWAY FROM
SAFELY DRIVING YOUR VEHICLE.
Any function that requires your prolonged attention
should only be performed after coming to a
complete stop. Always stop the vehicle in a safe
location before performing these functions. Failure
to do so may result in an accident.
4/25/05 4:51:37 PM
4/25/05 4:51:37 PM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pkg-1000

Tabla de contenido