M A I N T E N A N C E - Warn SXS Plow Push Tube Instrucciones De Instalación

IX. Maintenance/Care
• Inspect all metal parts on the plow, plow mount, and related hardware prior to each use. Replace all parts that
appear rusted or deformed.
• Inspect all nuts and bolts on the plow, plow mount, and related hardware prior to each use. Tighten all nuts
and bolts that appear to be loose. Stripped, fractured, or bent bolts or nuts must be replaced.
• Periodically check plow components during use. Remove debris buildup that may inhibit parts from moving
freely.
• After each use, use water and compressed air to clean all parts of the plow and remove any debris buildup.
Lubricate all moving [arts with a light oil to help prevent corrosion and keep mechanisms operating freely.
• Reference Warn Plow Operator's-Guide-Basic Guide to Plow for Maintenance and Storage.
Failure to perform regular inspections and maintenance on the plow, plow mount, and related hardware may result in
vehicle damage and operator injury or death.
The following replacement parts are available for purchase:
Part # Description
81868 Latch Handle kit
89887 Plow Bushing kit
81870 Stop Block and Spring Hanger kit
Contact your nearest WARN dealer for ordering. To find a dealer nearest you, contact the WARN dealer locator
line at 1-800-910-1122.
If you are having problems with your plow, please follow the steps below:
1. Reference the installation instructions for tips or notes.
2. Contact the dealer where you purchased the kit.
3. Call an authorized WARN Service Center from the warranty sheet included in the kit. Please have the
following information available before calling: part number (listed on front of instructions), date of purchase,
and make, model, and model year of ATV.
4. Contact WARN customer service at 1-800-543-9276 or www.warn.com. Again, please have the following
information available before calling: part number (listed on front of instructions), date of purchase, and make,
model, and model year of ATV.
WARN® INDUSTRIES
WARNING
Notes
1x 80409, 1x77412 fastener included.
2x 88987, 2x 80755 fasteners included
2x 80798, 2x 80406 fasteners included
PAGE 10 88853 Rev A1