Hayward Saline C Manual Del Usuario página 14

• •
•
WARNING
the equipment.
This document should be given to the owner of the swimming pool and must be kept by the owner
in a safe place.
•
WARNING
the swimming pool equipment.
•
WARNING
power disconnection means which should be readily accessible to the end user.
•
WARNING
local electrical standard.
F NF C 15-100
D DIN VDE 0100-702
A ÖVE 8001-4-702
E UNE 20460-7-702 1993, REBT ITC-BT-31 2002
IRL Normas de cableado + IS HD 384-7-702
I CEI 64-8/7
LUX 384-7.702 S2
NL NEN 1010-7-702
P RSIUEE
•
WARNING
protected from short-circuits. The product is to be supplied by an isolating transformer or supplied
through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.
•
WARNING
that of the distribution network and that the power supply cables matches the power and current of
the product.
•
WARNING
or cable gland appropriate for the applicable country are intended to be installed and replaced by a
manufacturer's authorized or qualified personnel.
•
WARNING
electric shock. A damaged power cord must be replaced by a service agent or a similarly qualified
person immediately in order to avoid a hazard.
•
WARNING
recirculation pump power source for the pool/spa to ensure that the Saline C system cannot operate
when the pumps are off.
•
WARNING
•
WARNING
of hydrogen gas does not occur.
•
WARNING Chemical Hazard
avoid death, serious injury or property damage: Wear eye and skin protection while maintaining or
servicing this unit. Do not inhale fumes from the unit.
Page 2 of 11
WARNING: Electrical Hazard. Failure to follow
instructions can result in serious injury or death.
– Read and follow all instructions in this owner's manual and on
Failure to follow
– Disconnect this product from the main power supply completely before servicing
– All pole power disconnection means shall be provided. Plugs are considered
– All electrical connections must be done by a qualified electrician according to
– Be certain the product is only plugged into a protected 230 V
– Make sure that the power supply voltage required by the product corresponds to
– Suitably rated CERTIFIED/APPROVED power supply cord, plug and strain relief
– Do not operate the product if the power cord is damaged. This can cause an
– When installing the system, ensure that power is interlocked with the main
– The unit shall not be operated when there is no water flow in the cell.
– The cell shall be located in a well ventilated environment so hazardous accumulation
– Chemicals can cause burns both internally and externally. To
USE ONLY GENUINE REPLACEMENT PARTS
FOR USE WITH SWIMMING POOLS
instructions can cause
GB BS7671:1992
EW EVHS-HD 384-7-702
H MSZ 2364-702:1994 / MSZ 10-533 1/1990
M MSA HD 384-7-702.S2
PL PN-IEC 60364-7-702:1999
CZ CSN 33 2000 7-702
SK STN 33 2000-7-702
SLO SIST HD 384-7-702.S2
TR TS IEC 60364-7-702
Saline C
™
serious injury or
outlet that is
death.
Rev. C