Stihl MDG 1 Manual De Instrucciones página 22

English
LED (2) Meaning
Flashes white: Ready for opera -
tion – no
connection to
computer
Glows continu - Ready for opera -
ously blue: tion – connected to
computer via
Bluetooth
Flashes blue: Data transfer in
progress
Glows continu - Bluetooth connec -
ously red: tion faulty
Plugging In and Connecting Bluetooth
USB Stick
Plugging in and connecting
automatically
Fully functional Bluetooth software is
integrated as from Microsoft
XP Service Pack 3. The Bluetooth USB
stick is detected and connected
automatically.
Plug Bluetooth USB stick into a free
N
USB port – go to "Connecting
Engine Analyzer to Computer".
Connecting Engine Analyzer to
Computer
Connect the engine analyzer to the
computer only after installing the STIHL
diagnostic software and the Bluetooth
USB stick.
Start STIHL diagnostic software.
N
The status bar shows
Searching for MDG 1
20
MDG 1 found
click once on "MDG 1" graphic –
N
status bar shows:
MDG 1 connected
If two or more engine analyzers (MDG 1)
are available, they are shown in a dialog
window with their serial numbers. Select
the required MDG 1.
Screen changes to "Initializing" view.
Light emitting diode above socket (2)
glows:
Continuous blue – ready for
–
operation – connected to computer
via Bluetooth
Flashes blue – data transfer
–
Now follow the operating
N
instructons for the STIHL diagnostic
software – observe safety
® ® precautions in STIHL diagnostic
Windows
software during operation.
The STIHL diagnostic software cannot
recognize the engine analyzer if the
connection is not correct. If the engine
analyzer is not recognized:
A
Check that light emitting diode (1)
N
glows green and light emitting diode
(2) glows continuously blue.
Light emitting diode (1) glows
continuously red: Internal fault – replace
analyzer.
Light emitting diode (2) flashes white: No
connection to computer – check
connection.
If no connection between engine
analyzer and computer has been
established up to this point, continue
with "Plugging in and connecting USB
stick manually". Manual connection is
necessary only if automatc connection
fails.
Plugging in and connecting bluetooth
USB stick manually
N
N
N
N
N
2
N
B
0/
1
N
N
Interference
Program flow may be interrupted by
electromagnetic interference. In such a
case, close the application and remove
Plug Bluetooth USB stick into a free
USB port.
Open Control Panel and select
Bluetooth devices.
In the list, click on add device – this
starts the assistant for adding
bluetooth devices.
Check the box – "Device is installed
and can be detected" – click "Next".
Search for Bluetooth devices begins
– select STIHL MDG 1 and click
"Next".
Select "Use main code from
documentation" – enter main code
STIHL (in capital letters) and click
"Next" – connection is made.
Press "Finish" to exit assistant.
Exit Bluetooth devices with "OK".
MDG 1