How To Work - Friedrich MR24UY3J Manuel D'installation

Split system ductless
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Nitrogen substitution method
Welding, as when heating without nitrogen substitution a large amount of the oxide film is formed
on the internal piping.
The oxide film is a caused by clogging EEV, Capillary, oil hole of accumulator and suction hole of oil
pump in compressor.
It prevents normal operation of the compressor.
In order to avoid this problem, Welding should be done after replacing air by nitrogen gas.
When welding plumbing pipe, the work is required.

◆How to work

Oxide scale
Note) should not block the outlet side.
When the internal pressure in pipe is abo
ve the atmospheric pressure, pinhole is o
ccurred and it is a leakage cause.
CAUTION:
1. Always use the nitrogen.(not use oxygen, carbon dioxide, and a Chevron gas):
Please use the following nitrogen pressure 0.02MPa
Oxygen --------- Promotes oxidative degradation of refrigerant oil.
Because it is flammable, it is strictly prohibited to use
Carbon dioxide --- Degrade the drying characteristics of gas
Chevron Gas ---- Toxic gas occurs when exposed to direct flame.
2. Always use a pressure reducing valve.
3. Please do not use commercially available antioxidant.
The residual material seems to be the oxide scale is observed.
In fact, due to the organic acids generated by oxidation of the alcohol contained in the
anti-oxidants, ants nest corrosion occurs. (causes of organic acid → alcohol + copper +
water + temperature)
Welding Point
Nitrogen gas
Pressure 0.02MPa less
Taping
(Should not
contain air)
Connecting Copper Pipes
Regulator
Auxiliary valve
Installation Manual 13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mr36uy3j

Tabla de contenido