minikon 900CT-2 Manual De Instrucciones página 8

PEDESTRIAN
DOOR OPEN
INDICATOR
PHOTOCELL
PHOTO 2
STARTING
TORQUE
WORKING TIME
PAUSE TIME
FLASHING UNIT
OR COURTESY
LAMP
The pedestrian command enables opening of one gate leaf
on a 2-leaf model. If dip switch 1 is selected (sliding mode)
the gate opens for 1/3 of the working time.
The gate open indicator lamp notifies the user of the gate status.
Gate closed - lamp off.
Gate in opening phase - slow flashing lamp.
Gate open - lamp lit.
Gate in closing phase - fast flashing lamp.
The photocell command ensures that on interruption of the light
beam, all controls are inhibited.
During the opening phase, if the beam is interrupted, the gate
completes travel to the normal pause position. During the pause
phase, if the beam is interrupted, the gate remains in this status
until the beam is restored. When the beam is restored, the gate
remains in pause for a brief interval (1/4 of the set time) and then
closes. During the closing phase, if the beam is interrupted, the
gate changes to the opening phase.
The command in photo 2 is activated in the opening phase causing
gate shutdown. On reset gate opening is resumed. If shut down
during closing, opening is resumed.
Thrust is activated on opening and closing setting the maximum
force for 1 sec. to then return to the set power of the autotransformer.
Working time range from 2 sec. to 60 sec. (with dip switch 4
inserted regulation range is from 2 sec. to 120 sec.).
The adjustment trimmer to facilitate brief time settings on gate
movements has an exponential control range (finer at the start
of trimmer travel and is less so at the end).
Pause time range from 2 sec. to 180 sec. N.B.: During opening,
if the photocell beam is interrupted, the pause time if reduced to
1/4 of the set time.
The courtesy lamp uses the same relay as the flashing unit, and
extends operation time is selected for a fixed interval of 3 min.
8
GB