Assembly - Craftsman 580.752300 Manual Del Usuario

Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
1. Open carton and slice two corners opposite guide
handle from top to bottom so panel can be folded
down flat.
2. Remove fillers, accesories and parts bag shipped
with your pressure washer.
3. Roll pressure washer out open end of carton.
4. Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• The main unit
• Handle
• High pressure hose
• Spray gun
• Nozzle extension with adjustable nozzle
• Engine oil
• Parts bag (which includes items listed below)
Owner's manual
Registration card
Handle attachment hardware
Become familiar with each piece before assembling
the pressure washer. Compare contents against the
view on page 5. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Attach handle to main unit.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect high pressure hose to spray gun and
pump.
5. Connect water supply to pump.

ASSEMBLY

Attach Handle
1. Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
Align Holes
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand.
3. Insert one "L" hooks through hole just under billboard
on left side of handle (viewing from rear of unit). Hold
hook in place with pliers and attach locknut with
7/16" wrench.
Hose Hook
4. Insert other "L" hooks through hole just above
billboard on right side of handle (viewing from rear
of unit). Hold hook in place with pliers and attach
locknut with 7/16" wrench.
6
Handle
Handle
Supports
Spray Gun
Hook