Add Engine Oil - Craftsman 580.752300 Manual Del Usuario

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher rated SAE 30
weight. DO NOT use special additives.
1. Choose a viscosity according to table below.
5W-30, 10W-30
Synthetic 5W-30, 10W-30
°F -20 0 20
°C -30 -20 -10
STARTING TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
* The use of multi-viscosity oils (5W-30, 10W-30, etc.)
in temperatures above 40°F (4°C) will result in higher
than normal oil consumption. When using a multi-
viscosity oil, check oil more frequently.
** If using SAE 30 oil in temperatures below 40°F
(4°C), it will result in hard starting and possible
engine bore damage due to inadequate lubrication.
1. Place pressure washer on a level surface.
2. Clean area around oil fill.
3. Remove oil fill cap and dipstick.
4. Wipe dipstick clean, insert it into oil fill hole and
tighten securely, remove dipstick. Add
recommended oil up to "Full" mark on dipstick.
5. Pour slowly. Wipe dipstick clean each time oil
level is checked. DO NOT overfill.
6. Install oil fill plug and dipstick, tighten securely.
NOTE: Check oil often during engine break–in.
30
32 40 60 80
0 10 20 30
Add Gasoline
WARNING!
NEVER fill fuel tank when engine is running or
hot. DO NOT smoke when filling fuel tank.
WARNING!
full. Provide space for fuel expansion. Wipe
away any fuel spillage from engine and
equipment before starting.
1. Use clean unleaded automotive gasoline and store
in approved, clean, covered containers. Use clean
fill funnels. NEVER use "stale" gasoline left over
from last season or gasoline stored for long
periods.
100
2. Clean area around fuel fill cap, remove cap.
40
3. Slowly add gasoline to fuel tank. Use a funnel to
prevent spillage. Fill tank to about 1.5" below the
top of the filler neck.
4. Install fuel cap and wipe up any spilled gasoline.
IMPORTANT: It is important to prevent gum deposits
from forming in essential fuel system parts, such as
the carburetor, fuel filter, fuel hose or tank during
storage. Also, experience indicates that
alcohol–blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leads to
separation and formation of acids during storage.
Acidic gas can damage the fuel system of an engine
while in storage.
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer. See
"Storage" on pages 16-17. NEVER use engine or
carburetor cleaner products in the fuel tank or
permanent damage may occur.
7
NEVER fill fuel tank indoors.
NEVER fill fuel tank completely
Tank
Fuel