Samsung WF45R6300A Serie Manual Del Usaurio página 35

05 Spin
06 Soil
07 Pre Soak
08 Steam
09 Super Speed
10 Delay End
Untitled-18 35
Press to change the spinning speed for the current cycle.
• High (Level 5): Extends the spinning process to effectively
remove moisture from the load. This level uses a stronger
spinning process to remove moisture, so it is not suitable for
wrinkle-free or non-iron fabrics, or overloads.
• (Level 4): Underwear, t-shirts, jeans, and sturdy cottons.
• (Level 3): Jeans, wrinkle-free or wash-and-wear items, and
synthetics.
• (Level 2): Delicate items that require a lower spinning speed.
• No Spin (Level 1): The drum does not spin after the nal drain
process.
Rinse hold (All indicators are off): The nal rinse process is
suspended so that the laundry remains in the water. To unload the
laundry, run a drain or spin process.
NOTE
Spin Only: To perform the spin process only, press and hold Spin for
3 seconds. With the cycle time on the display, press Spin repeatedly
until a desired spinning speed is selected. Then, press and hold Start/
Pause (Hold to Start) to start.
Press to change the soil level for the current cycle.
• Heavy (Level 5): For extremely soiled loads.
• (Level 4): For heavily soiled loads.
• (Level 3): For moderately soiled loads. This setting is best for
most loads.
• (Level 2): For lightly soiled loads.
• Light (Level 1): For barely soiled loads.
Press to add 30 minutes of soaking time at the start of the wash
cycle for better stain removal.
Press to use the Steam function. The Steam function is available
with NORMAL, HEAVY DUTY, WHITES, BEDDING, and SANITIZE. For
heavily soiled, colorfast items, this function improves stain treatment
and uses less water.
Press this button if you need to shorten the washing time, applicable
for NORMAL, WHITES, HEAVY DUTY or BEDDING. The shortened time
may differ depending on the selected cycle/load/options.
Set the washer to nish your wash automatically at later time.
Choose a delay of between 1 to 24 hours (in 1 hour increments). (For
more information about Delay End, see page 41.)
English 35
2019-01-23 3:36:35