Johnson Health Tech Matrix C50 Manual Del Usuario página 10

MAINTENANCE
Preventative maintenance is the key to smooth operating
equipment, as well as keeping the users' liability to a minimum.
Equipment needs to be inspected at regular intervals. Defective
components must be replaced immediately. Improperly
working equipment must be kept out of use until it is repaired.
Ensure that any person(s) making adjustments or performing
maintenance or repair of any kind is qualified to do so.
MAINTAIN LABELS AND NAMEPLATES: Do not remove
labels for any reason. They contain important information.
If unreadable or missing, reference contact information
on the INFORMATION CARD for replacement.
WARNING
To remove power from the ClimbMill, the power cord
must be disconnected from the wall outlet.
AUTO STOP SENSORS
10
MAINTENANCE SCHEDULE
ACTION
Clean and inspect the ClimbMill:
• Turn off the machine with the ON/OFF switch, then unplug the power cord at the
wall outlet.
• Clean entire machine using water and a mild soap applied to a soft cloth. Never
use solvents, as they can cause damage to the ClimbMill. Never spray cleaner
directly onto the machine or console.
• Inspect the power cord. If the power cord is damaged, please reference contact
information on the back cover of the INFORMATION CARD for assistance.
• Make sure the power cord is not underneath the machine or in any other area
where it can become pinched or cut during storage or use.
• If any labels are damaged or illegible, please reference contact information on
the INFORMATION CARD for replacement.
Clean underneath the machine:
• Turn off the machine with the ON/OFF switch, then
• unplug the power cord at the wall outlet.
• Remove the debris tray from under the machine by sliding it out from the right
side and wipe or vacuum any grease, dust particles or other objects that may
have accumulated on it. Return the debris tray to its previous position.
• Wipe or vacuum any dust particles or other objects that may have accumulated
around the machine.
Unplug the ClimbMill and clean the AUTO STOP SENSORS (located under the
bottom step).
IMPORTANT!
• Turn off the machine with the ON/OFF switch, then unplug the power cord at the
wall outlet. Wait 60 seconds.
• Inspect all assembly bolts of the machine for proper tightness. Reference
assembly steps for proper tension of each bolt.
• Remove the front access cover. Wait until ALL LED lights turn off.
• Clean the motor and lower board area to eliminate any lint or dust particles that
may have accumulated. Failure to do so may result in premature failure of key
electrical components.
• Check step motion by rotating the steps backwards to ensure free movement.
• Check stability to ensure the ClimbMill does not rock or wobble. Adjust levelers as
necessary.
FREQUENCY
BEFORE EACH USE
WEEKLY
WEEKLY
MONTHLY