Installation Instructions - Sengled Z01-A60EAE27 Manual De Instrucciones

EZ-Mode commissioning from the bulb: Power cycle
the bulb (off then back on) seven times quickly to
enable EZ-Mode. The bulb will blink to indicate that it is
in this mode for three minutes. To exit this mode earlier,
power off the bulb via the wall switch, wait for two
seconds and then power it back on.
Setting the bulb's dim level via wall switch: Enable
dimming by powering the bulb off and then on within
one second. The light will gradually change from its
current brightness setting to the maximum. Following
this, the brightness will change from the maximum to
the minimum and finally back to the maximum again.
When the brightness is changing, power off the bulb
when the bulb reaches the desired dim level. Power the
bulb back on and the bulb should now be set to the
new dim level. If no power off action is taken, the light
will remain at maximum brightness level.

INSTALLATION INSTRUCTIONS

Note: This bulb works with Sengled Element hub!
• Open Sengled Element App.
• Turn the bulb switch to OFF position prior to installing the
LED bulb.
• Please follow the in-app instructions to scan, power on and
add the bulbs to their desired hub as shown below. If needed,
power cycle the bulb to re-enter the pairing mode after three
minutes.