Recording; Snapshot - Papago GoSafe 318 Manual Usuario

Recording

● Repeat Recording
○ Insert the MicroSD in the MicroSD socket. Loop recording begins after the Dashcam is
turned on.`
○ The default length of each session is 5 minutes.
○ When the MicroSD is full, new recordings will replace old recordings.
Remove the MicroSD from the Dashcam only after the Dashcam is turned off
completely to prevent files from becoming damaged. Do not remove the
MicroSD from an operating Dashcam to prevent system damage.
● Emergency Recording
○ Auto Emergency Recording
When "G-Sensor" is enabled, the Dashcam will automatically write-protect the clip
recorded during the time when an impact is detected to prevent the footage from being
recorded over with the loop-recording mode.
Set the sensitivity of impact detection from "Settings—GSensor".
○ Manual Emergency Recording
While a clip is being recorded, press the "
it from getting recorded over with the loop-recording mode.

Snapshot

● While a clip is recording, press "
● The snapshot function will not affect video recording.
" to write-protect the current clip and protect
REC
" to take a snapshot.
English 13