Nightlight; Room Temperature - NUK Eco Control Audio 530D+ Instrucciones De Operación

– If you choose to switch the lullabies on
anyway, there may be a delay of up to
30 seconds before they begin. In Eco-
Mode, the activation command is not
transmitted until the next range check
is carried out (see "Range check in
Eco-Mode" on page 35).

6.11 Nightlight

The Nightlight function provides for a soft
dim light in the nursery.
Note: You can alternatively switch the
nightlight on and off from the baby unit itself
(see "5.4 Nightlight" on page 37).
1. You activate the function by briefly
pressing the Nightlight on/off button 25.
The nightlight 5 switches on.
The display
lightbulb symbol.
2. You switch the function off by briefly
pressing the Nightlight on/off button 25
again.
The nightlight 5 switches off.
The lightbulb symbol disappears.
Nightlight in Eco-Mode
Please note! There are a number of special
features while the babyphone is in Eco-
Mode (see "4.5 Eco-Mode and FULL-ECO-
CONTROL" on page 35):
• The "Nightlight" function is temporarily
deactivated so
inadvertently disturb baby.
In this case
symbol will flash while the
FULL-ECO-CONTROL function
checks the
between the two units.
– To prevent the nightlight from switching
on later, you can again press the
Nightlight on/off
immediately cancel the function. The
flashing symbol will then disappear
from the display.
– If you choose to switch on the
nightlight anyway, there may be a delay
17 shows the
that you do
the lightbulb
connection
button 25
of up to 30 seconds before this
happens. In Eco-Mode, the activation
command is not transmitted until the
next range check is carried out (see
"Range
page 35).

6.12 Room temperature

The correct room temperature is particularly
important for baby's healthful sleep. The
baby unit of this NUK babyphone therefore
has an integrated temperature sensor.
The temperature in the nursery is always
shown on the display 17 and is updated
automatically.
Note: Since the temperature sensor is inside
the baby unit it is important that you do not
cover it or place it near the heating. Direct
sunlight may also affect the reading.
The baby unit checks the room temperature
and sends warnings to the parent unit. The
following signals are displayed on the
display of the parent unit:
Display
LO The temperature has fallen below
flashing the lower threshold of 10 °C.
The room temperature has
reached an extremely critical
level and urgent action is
required to increase the
temperature in the nursery.
not
10 °C to This temperature is too low for
15 °C baby to sleep properly.
flashing
Check the heating and adjust it if
necessary.
15 °C to This temperature is suitable for
30 °C baby to sleep properly.
30 °C to This temperature is too high for
35 °C baby to sleep properly.
flashing
Check the ventilation or air-
to
conditioning and adjust it if
necessary.
42
check in Eco-Mode"
Significance / Action
on