Dune HD Base 3.0 Guia De Instalacion página 8

Connecting USB Drives
To connect a USB drive, ensure you are on the main screen of the player menu and connect the USB drive
to an USB port of the player. The player will recognize the USB drive, and will show an item corresponding
to the USB drive on the main screen.
When connecting a USB drive requiring significant power (such as USB HDD), use an external power
supply for the USB drive. Power provided by the USB ports of the player may not be enough for correct
functioning of the USB drive.
Do not disconnect or switch off the USB drive when some write operation is in progress.
Connecting eSATA Drives
To connect an eSATA drive, switch off both the player and the eSATA drive, connect the eSATA drive to the
eSATA port of the player (and connect the eSATA drive to its power supply), switch on the eSATA drive,
and, as the last step, switch on the player. The player will recognize the eSATA drive, and will show an item
corresponding to the eSATA drive on the main screen of the player menu.
Switch off and disconnect the eSATA drive only after switching off the player.
Formatting HDD
To format a HDD attached to the player, select the drive item on the main screen of the player menu, press
the "INFO" RC button and choose "Format Disk" (to format the entire disk) or "Format Partition" (or to for-
mat an already existing disk partition only). The player will format the disk using "EXT2" filesystem. NOTE:
To use disks formatted by the player on a Windows PC, you may need to install additional software on the
PC, such as "EXT2FSD" (http://www.ext2fsd.com/).
Accessing Network Drives
To connect a network drive using SMB or NFS protocol, ensure you are on the main screen of the player menu,
press the "MENU" RC button, and choose "Create Network Folder", then fill the parameters of the network drive
as needed. The player will show an item corresponding to the configured network drive on the main screen.
To browse the list of network resources accessible via SMB or UPnP protocols, use "Network Browser"
item on the main screen of the player menu. NOTE: If some network resources are not shown by the
player, you may need to wait some minutes and then retry (or press the "MENU" RC button and choose
"Refresh" command).
Power Off and Standby
To switch off the player completely, toggle the power switch on the front panel. After the player is switched
off, it is recommended to wait about 1 minute before switching it on again. NOTE: Do not switch off the
player if some drive is connected to the player and some write operation is in progress.
To put the player into the standby mode, press the "POWER" RC button. In the standby mode, the player
produces no signal on the video output, but is still functioning. For example, if you have some storage
devices connected to the player, you may still access them from network ("NAS" function of the player).
To exit the standby mode, press the "POWER" RC button again. Exiting the standby mode takes just a
few seconds. NOTE: When the player is in the standby mode, it still consumes significant power. It is not
recommended to keep the player in the standby mode for a while if you do not need it.
8
Dune HD Base 3.0 Quick Start Guide