Wolf EC24B Guia De Instalacion página 7

INSTALLATION
Installation
Ensure the sides of the cabinetry opening are adequate
1
to support installation of the slides. If necessary, install
additional side cleats maintaining the opening width.
Position slides on the sides of the cabinet opening as
2
shown in the illustration below. Spacer material provided,
can be added under or at the sides of the cabinet to
ensure a proper fit. If the unit is to be installed over a
warming drawer, use the top surface as a reference
to position slides (there will be no surface to rest the
slides on).
Secure the slides with screws provided. Extend slides
3
forward to full extension.
14"
(356)
10"
(254)
3
/ "
4 (19)
TYPICAL
Slide support. Install slides.
Position the unit on the slides. Verify the pins are inserted
4
into the housings properly, then secure with screws pro-
vided. If the height of the unit requires adjustment, use
the spacer disks provided. Refer to the illustration below.
Secure the power cord clip provided to the top of the
5
cabinet opening, centered and approximately 14"
back from the front edge. Position the power cord
through it and plug into the electrical outlet on the
back wall of the opening. The power cord must be long
enough to allow the unit to be slid forward.
SPACER DISK
Install unit on slides.
(356)
POWER
CORD CLIP
C L
Install power cord clip.
| |
wolfappliance.com wolfappliance.com 7 7