NAIM UnitiServe Guia De Inicio Rapido página 3

UnitiServe Quick Start Guide
2 R i pp ing Musi c
• Insert a CD into the loading slot.
• UnitiServe will begin ripping automatically. To view progress, select
Home
menu. The CD will be ejected automatically when ripping is complete. A typical CD will take
up to eight minutes to rip.
CD loading slot
3 L ocal Mus i c Playbac k
• Select Browse Music from the
menu select an item and select
• Selecting the Quick Play
popular, recently played and newest items.
4 Ne t wo r k M usi c Playback
• UnitiServe is a UPnP™ (Universal Plug and Play) server device. Ripped music is automatically made
available to any UPnP™ playback device connected to the network.
• Switch on a playback device and search through its list of connected servers for the UnitiServe (e.g.
NSSRV4567). Select the UnitiServe followed by the desired material for playback.
5 Sw itc hi ng O f f
• Switching off your UnitiServe from its rear panel power switch is not normally necessary.
• UnitiServe can be put into shutdown mode by touching the front panel logo for five seconds. The
logo will flash as UnitiServe shuts down.
To switch your UnitiServe back on from shutdown mode, the rear panel power switch must be
switched off and on again.
Do not switch off UnitiServe from the rear panel power switch or disconnect it from mains
•
power until it is in shutdown mode.
Full installation and operational information can be found in the UnitiServe Reference Manual included on the CD packed
touch logo
Home menu and then either
Play.
menu from the Home menu provides short-cut access to the most
with the product, or available at www.naimaudio.com
Ripping Monitor from the
manual eject access hole
(see note)
Albums or Artists. From the following
English
Note:
UnitiServe is able to
play CDs directly as well
as ripping them. CD play is
initiated from the System
Setup menu.
Note:
Ripping a CD you
do not personally own
may constitute a violation
of copyright law. You
must ensure, if inserting
a borrowed CD, that the
UnitiServe is configured to
play the CD only.
Note: To abort a rip and eject
the CD, touch the front panel
Naim logo.
Note:
UnitiServe is only able
to catalogue ripped CDs if it is
connected to the internet.
Note: UnitiServe includes
some music pre-ripped when
manufactured.
Note:
Music stored by
UnitiServe is not automatically
backed-up. Network storage
hardware should be used for
back-up. See the Reference
Manual.
Note: UnitiServe may be
unable automatically to eject
CDs that are outside usual
manufacturing tolerances. If
this occurs, carefully insert
an unfolded paperclip into
the access hole and push
to actuate the manual eject
mechanism.