Front Panel - Denon DN-312X Guia Del Usuario

Features

Front Panel

3
5
1. Power Switch: Use this switch to power DN-312X on or off.
2. Power Light: This light illuminates when DN-312X is powered on.
3. Mic In Level: Turn these knobs to set the input level of the corresponding mic/line inputs
(Channels 1–6).
4. Stereo In Level: Turn these knobs to set the input level of the corresponding line inputs
(Channels 7/8–11/12).
5. Signal (Sig) Lights: Indicates that the channel's incoming audio signal is within an optimal
range.
6. Mic Level: Turn this knob to set the input level of the Mic Monitor output. Use the Mic
On/Off button to enable to disable it.
7. Mic On/Off: Press this to turn enable or disable the Mic Monitor output. When the button
is depressed (in the down position), the signal from the mic/line inputs (Channels 1–6) will
be sent to the Mic Monitor output, and the Line Outs will be disabled. When the button is
raised (in the up position), the Mic Monitor output will be disabled, and all channels will be
sent to the Line Outs.
8. EQ: Turn these knobs to increase ("boost") or reduce ("cut") the amount of bass frequencies
(Low), mid-range frequencies (Mid), and treble frequencies (High) of the main mix.
9. Mono Level: Turn this knob to adjust the level of the Mono Out.
10. Master Level: Turn this knob to adjust the level of the Line Outs, Mono Out, and Rec Out.
11. Level Meters: These lights indicate the audio level of the Line Outs, Mono Out, and Rec
Out. The Clip light can light up occasionally, but if it happens too often, reduce the volume
of the mix and/or individual channels.
6
4
7
8 9
10
11
2
1
3