Denon DN-312X Guia Del Usuario página 5

Setup
Items not listed under
To set up DN-312X with your sound system:
1. If you are using any audio source with RCA outputs (Blu-ray
standard RCA cables to connect them to the line inputs on the rear panel. Your audio
sources must be line-level (no phono-level turntables).
2. If you are using microphones or other audio sources that send a line-level signal, connect
them to the mic/line inputs on the rear panel.
3. Use standard XLR or 1/4" (6.35 mm) TRS cables to connect the line outputs on the rear
panel to your loudspeakers, remote mixer, etc.
4. If you want to send the main mix to a remote recording device, remote mixer, etc., use a
standard 1/4" (6.35 mm) TS cable to connect the Mono Out on the rear panel to it.
Alternatively, use standard stereo RCA cables to connect the Rec Outs on the rear panel to it.
5. Use the included power cable to connect DN-312X to a power outlet.
6. Power on all of your audio sources (Blu-ray players, stereos, microphones, etc.).
7. Power on DN-312X.
Example
Loudspeakers
Introduction Box Contents
Blu-ray Player
are sold separately.
(to input on
remote mixer)
®
players, stereos, etc.), use
Microphones
5