Transmitting Test Signals - Honeywell HB 85 Montaje Y Operación

Commissioning

Transmitting test signals

The brightness sensor module can transmit a test signal to the Homet-
ronic Manager HCM 200D to check the signal strength.
In the HCM 200D, select "Menu/Settings/Installation/Receive
►
Test MSG.".
The following specifications appear in
the display:
– Device number of the sensor
– Strength of the received signal
(1 = sufficient, 5 = strong)
– Number of received test mes-
sages
Press the Binding button on the bright-
►
ness sensor module briefly.
The brightness sensor module trans-
mits a test message to the
HCM 200D every 5 seconds
(for approx. 10 minutes).
34
Source ID 00-002628
Field strength
Received Msg.
4
212