Publicidad
Installation Instructions
9.
Mount junction box base on expediter. Make sure to align
slots to properly orient junction box base. Tighten nut with
Terminator-LN-Tool. If mounting horizontally, threaded
gland holes must face downward.
10.
Install M25 power gland and M25 blind plug. For in-line
splice, T-splice, or end termination, install additional M25
blind plug (order M25-B-EXE separately) instead of M25
power gland.
11.
Install power cable (if necessary). The insulation on the
conductors is to be stripped back in accordance with the
terminal block manufacturer's recommendations.
12.
Install quick mount terminal blocks and tighten screws (if
necessary).
13.
Complete system wiring. Terminal set screws shall be
tightened to a torque value of 1.4 Nm (12.4 lb-in). See page
5 for wiring details.
14.
Install junction box lid and twist hand tight. Insert screw-
driver into ratchet slots located on side of junction box base.
15.
Use screwdriver to ratchet on junction box lid. Lid will rotate
30 degrees.
16.
Lid latch mechanism fully engaged. To remove lid, repeat
steps 14 and 15 but in the opposite direction.
3
Publicidad
