Threading The Machine; Winding The Bobbin - Brother 885-403 Manual De Instrucciones

THREADING THE MACHINE

Winding the bobbin

This section describes how to wind the thread onto the bobbin.
1 Pulling it in as
far as possible.
CAUTION
● We designed the bobbin that comes with this machine. If you use bobbins from other models, the
machine will not work properly. Only use the bobbin that comes with this machine or bobbins of the
same type (part code: SA156, SABOBBIN, SFB: XA5539-151).
a 11.5 mm (7/16 inches)
a Pull up the spool pin as far as possible, and
then put a spool of thread on this pin.
b Pass the thread around the pre-tension disk.
a Pre-tension disk
CAUTION
● If the spool of thread is not in the right place,
the thread may tangle on the spool pin.
c
Pass the end of the thread through the hole on
the bobbin from the inside of the bobbin.
a Pre-tension disk
b Bobbin winder shaft
c Bobbin
Actual size
This model Other models
d Put the bobbin onto the bobbin winder shaft and
slide the bobbin winder shaft to the right. Turn
the bobbin clockwise, by hand, until the spring
on the shaft slides into the groove of the bobbin.
• Align the notch on bobbin to the spring on
the shaft.
a Spring on the shaft
b Groove of the bobbin
e
Turn on the sewing machine.
1
10