Troubleshooting - Sage Kitchen Wizz Pro BFP800 Guía Rápida

TROUBLESHOOTING

PROBLEM
Food is unevenly
processed
Slices are slanted
or uneven
Food falls over
in the feed chute
Chipper disk
Some food remains
on the disc after
processing
Motor slows down
when mixing dough
Motor slow to start
with the 4 blade
processor
The motor does
not start
EASY SOLUTION
• Ingredients should be cut evenly into 2.5cm pieces
before processing.
• Ingredients should be processed in batches to
avoid overloading.
• Load food in feed chute. Place pusher onto food and apply
pressure. Then press start.
• The large feed chute must be packed full for best results.
If processing smaller quantities, use the small feed chute.
• Always clear any blocked potato from the chipper disc before
processing more potatoes.
• It is normal for small pieces to remain after processing.
• Amount of dough may exceed maximum capacity.
Remove half and process in two batches.
• Dough may be too wet (see next page). If motor speeds up,
continue processing. If not, add more flour, 1 tablespoon
at a time until the motor speeds up. Process until dough
cleans the side of the processing bowl.
• The amount of meat may have exceed the maximum capacity.
Refer to the Instruction Booklet for maximum quantities.
Remove the meat and process in two batches.
• Note that for best results trim the meat of fat
before processing.
• There is a safety interlock switch to prevent the motor from
starting if it is not properly assembled. Make sure the processing
bowl, lid and the pusher are securely locked into position.
• If you are slicing or shredding and the above solution does not
work, make sure that the food contents in the feed chute are cut
below the maximum fill line so that the activation rod can engage
the motor.
• If the motor still will not start, check the power cord and
power outlet.
EN
15