Powerpack; Overload Protection - Lister Liberty Manual De Instrucciones Y Lista De Piezas

Powerpack

The pocket-sized Lister Powerpack gives you the freedom to clip where you please
Charging the Powerpack
• Charge using the supplied Lister charger only (15V
• Charge indoors only. The charger must be kept dry at all times
• The powerpack requires a full 14 hour charge before first use. Full capacity may not be reached until it has been
charged and discharged 3 times. So clipping time may be reduced for the first 3 times it is used
• Connect the Powerpack to the charger cable and plug the charger into the mains
• A full charge takes between 11 and 14 hours
• Partial charging and discharging will not damage the Powerpack. The energy stored is proportional to the time
spent charging
• Overcharging will not damage the Powerpack, but it should not be left permanently charging when not in use
• When not in use, disconnect the Powerpack from the clipper
Clipping using the Powerpack
• Ensure that the Powerpack is securely clipped to a belt or to clothing, or held firmly in a pocket. Connect the clipper
lead to the Powerpack
• Oil the blades every 5-10 minutes (see Figure 5)
• Disconnect when not in use, and before removing or fitting blades
• A full charge lasts approximately 2 ½ hours. Once the clipper begins to noticeably slow down, turn off the clipper
immediately and recharge the Powerpack. Do not completely drain the Powerpack. Over discharging will cause
damage to the battery cells

Overload protection

• The Powerpack is fitted with a resettable fuse to protect the battery and clipper from overloading. This will trip if
there is a problem, such as blunt or clogged blades, lack of oil, excessive blade tension, or if the Powerpack needs
recharging
• The problem must be rectified before resuming clipping. Disconnect the Powerpack, and then clean and oil the
blades. Press the RESET switch to resume clipping (see Figure 7)
• Never hold the RESET switch down to prevent it from tripping. Continuous use of the RESET switch may damage
the resettable fuse and the clipper
Maintenance and storage
• Regularly check the connections and the charger cable for damage
• Store at room temperature in a clean dry place, out of the reach of children, and away from reactive chemicals or
naked flames
• The Powerpack should be stored fully charged. It will gradually lose its charge over long periods of storage, so it
should be fully recharged for 14 hours every 6 months. If it loses most of its charge, it will not regain its full capacity
until it has been charged and discharged 3 times. If it is completely drained of charge for long periods then the
battery cells may be damaged.
Technical information
• Voltage
• Overload Current
• Capacity
• Weight
• Battery cells
• Casing material
4
/ 400mA)
12V
4.5A
4300mAh
0.8kg
10 x 1.2V Nickel Metal Hydride cells
PC+ABS