Maintenance - Premium PCH796DR Manual Del Usuario

MAINTENANCE

CAUTION: NEVER PUT YOUR HAND INTO THE AREA HOUSING WHILE
THE FAN IS OPERATING.
FOR THE OPTIMAL LEVEL OF OPERATION, CLEAN THE RANGE HOOD
SURFACE, FAN, AND FILTER REGULARLY.
1. Use only mild soap or detergent solutions to clean the cooker hood surface. Dry
surfaces using soft cloth.
2. Using a stainless steel cleaner to bring the glow back into a stainless steel finish.
3. Clean the aluminium filter once a week or according to use status. Press the buckle
of the aluminium filter slightly, take off the aluminium filter and put it into warm soapy
water using mild detergent, wipe the filter with soft brush. Replace the filter after it is dry.
4. Clean the motor fan and other inside parts once half year or according to use by
QUALIFIED PERSON.
5. DO NOT cleaning motor with water or other liquid.
TO REPLACE LAMP
To replace LEDlamp (Pic.1)
Caution: LED lamp can not replace a new bulb, just can replace a new LED Lamp.
Make sure all the control switches are off, and he cooker hood is unplugged!
Please follow below instructions:
1.Take out the filters, and cut off the wire connection of the lamp.
2.Press the spring according to the arrow direction, then
you can take off the lamp unit.
3.You can replace a new LED lamp unit no more then rating!
4. Then put the lamp unit to the hood in reverse direction. Connect the wire of the lamp.
5. Fit on the filters.
To replace normal lamp bulb(Pic.2)
Caution :lamp unit may be hot! Wait until the unit is cool.
And use the same type light bulb!
Make sure all the control switches are off, and the cooker hood is unplugged! Please follow
below instructions:
Warning: Make sure the bulb is cool before you touch it!
1.Take out the filters.
2.Loose the old light bulb.
3.Replace a new light bulb which is the same type no more
than rating!
4.Fit on the filters.
Pic.1
Pic.2
12
INSTALACION PARA MODELOS PCH760R,PCH762DR,PCH794DR,PCH796DR,
PCH767DR,PCH797DR
Paso 1:
Por favor ponga la campana en la pared y
marque la posición en la que la desea instalar.
Recomendamos que la altura desde la estufa
hasta la parte inferior de la campana debe ser
entre 650 mm hasta 700 mm.
Tubo de expansión
Tornillo de madera
Paso 2:
Marque los cuatro agujeros en la pared de la
232mm
Gancho A B
forma que aparece en esta figura. Taladre 4
agujeros de 8 mm de diámetro y 60-70 mm de
profundidad en la pared donde usted los
marcó. Presione los 4 tubos de expansión
dentro de los agujeros. Apriete los 4 tornillos
Expanding Tube
de madera de 5x60 mm que se proveen dentro
A B
de los tubos de expansión. Asegúrese que
estén suficientemente apretados y que no se
Back of the hood
puedan mover.
5x60
Wood Screw
Tubo de escape Paso 3:
Fije el tubo de escape (153 mm diámetro de
lado) al cierre.
Cierre
Paso 4:
Soporte
Fije el gancho del ducto interno con los
tornillos M4.
Tornillo M4
Ducto interior
4